BishopSound BP4k 2 Channel Power Amplifier 3000w RMS
Key Features
- 2 x 1500 Watts RMS into 4 Ohms or 2 x 1000 Watts RMS into 8 Ohms
- Soft start - DC and short circuit protection, overload and distortion limiting
- Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
- 115/240v with Powercon mains lead and rear mounted circuit breaker for added protection
Description
The BP4K is a 2-channel Class D Power Amplifier with 3000 watts RMS of output power. At 4 ohms the BP4k 2 x 1500 watts at 8 ohms and 2 x 1000 watts of power. Professional amplification requires locking powercon input not IEC kettle lead. A fast push-to-make circuit breaker protects the amplifier at the rear mains input.
Class D amplification ensures a truly powerful sound inside a 1u compact and lightweight unit. With full protection against short-circuiting, overheating, DC voltage, power on/off transients and soft-start, the BP4k power amp ensures a safe, reliable performance.
There are level controls for each channel and the steel chassis housing also includes 2 x XLR inputs and 2 x SpeakOn outputs.
Power, signal and clip lights reveal the status of each of the 2 channels whilst 4 hi-speed thermally controlled fans draw air in through the front and out at the rear.
Designed and engineered in the UK, the BishopSound BP4k includes a number of features to give the best performance for passive speakers.
Here are the key features:
- 2 x 1500 Watts RMS into 4 Ohms
- 2 x 1000 Watts RMS into 8 Ohms
- 110v/240v switchable
- Independent gain on each channel
- Light and compact only 5kg in total
- Frequency Range: 30Hz - 20kHz ±1 dB
- Intelligent fans switch in and out dependent on the heat generation automatically to ensure cool running
- Limiters protect the BP4K from damage by moving to protect mode when THD is more than 0.5%
- Each of the 2 channels has an independent clip, protection and signal indication.
- Strong 1u four-bolt M6 rack ears for easy touring rack installation
- 2 x XLR balanced Neutrik analogue audio inputs
- 2 NL4 Neutrik speakON output connectors
Protection:
- Soft Start
- DC
- Short Circuit
- Overload
- Distortion limiting
- Overheating
- VHF
Designed to run down to 200v at which point the amplifier will go into protect mode. As soon as the voltage is restored you can use the amplifier again. This is important if you are running a power amplifier off a generator with an unstable power regulator.
Always use a power conditioner with this product for your safety and to protect your expensive PA.
1U amplifiers must be kept cool! High-speed fans are built-in but the only source of airflow is from the front vents so it is of the utmost importance to check monthly and keep these clean and free from clogging up with dust and dirt.
Technical Specifications
Product Weight | 5kg |
Product Depth | 25cm |
Product Height | 5cm |
Product Width | 48cm |
Intelligent fans | Switch in and out dependent on the heat generation automatically |
Limiters | Protect the BP4K from damage by moving to protect mode when THD is more than 0.5% |
LED | Each of the 2 channels has an independent clip, protection and signal indication. |
Size | 1u |
Inputs | 2 x XLR balanced Neutrik analogue audio inputs |
Outputs | 2 x NL4 Neutrik speakON output connectors |
Power Cable | Powercon cable included |
RMS | 3000w |